AODELAN E2 - Connecting to the Camera

Connecting to the camera
Via hot shoe
(Figure 3)
1. Turn off the camera and E2.
2. Slide the Hot Shoe Mounting Foot [20] of
the E2 into the camera’s hot shoe mount.
3. Lock the E2 by sliding the Mounting Foot
Lock Lever [19] to right until the lock
lever clicks in place.
4. Turn on the camera and E2 and set the
shooting mode of the camera to manual.
5. To detach E2, press the lock-release
button on the Mounting Foot Lock Lever
[19] while slide the lock lever all the way
back to the left, then slide the E2 out of
camera’s hot shoe mount.
(Figure 3)
• 11 •