Master Mode
1. In Master mode, the same remote control
command is sent to all Groups on the
selected Channel.
2. Press the Master Button [11], all Groups
are selected and will be affected by the
remote control commands.
Command Confirmation
1. If the output energy of a ash light
has been set to maximum or minimum
level, then the ash cannot continue to
increase or decrease its output energy
as commanded by the E2.
2. At the point E2 will make continuous and
short beeps to signal that the command
was not executed.
3. The energy of all ash lights in the group
will remain unchanged.
Test Function
1. When the E2 is in Transmit Mode, press
the Test Button [8] to manually transmit
a sync signal for remote camera shutter
• 18 •
To Next Page
Loading...