AODELAN E3+ - Page 36

34
1. Press master unit’s < >button to set the ash mode to< >.
2. Set the number of firing groups and flash output for each group by
referring to manual ash on the preceding page.
3. Set the ash frequency and number of ashes:
When
is displayed, press function button 2 corresponding to ,
turn<
> to set the number of ashes and press < >button;
Press function button 3 corresponding to
, turn < > to set the ash
frequency and press <
>button.
Note:
1) High speed sync function is not available when using stroboscopic
ash.
2) E3
+
receiver does not support MULTI mode.