AODELAN E3+ - Trouble Shooting Guide

48
VII. Trouble Shooting Guide
1. Power does not turn on
1.1 Make sure the batteries are installed in correct orientation.
1.2 Check battery contacts are in good contact and that the batteries are
sufcient with power.
2.The Slave unit doesn’t re
2.1 Check if the slave unit supports radio transmission wireless ash
2.2 Set the slave unit to <
>< >.
2.3 Set the transmission channels and wireless radio IDs of the master
unit and slave unit to the same numbers.
2.4 Check if the slave unit is within the transmission range of the master
unit.
2.5 If using E3
+
receiver, please refer to the receiver’s manual instruction to
check the operation.
3. <
>is displayed
Set the shutter speed 1 stop slower than the ash sync speed.