19
The slave units can be speedlites that is compatible with radio transmission
wireless shooting and set on slave mode, and also, by using with E3
+
receiver,
other Canon ETTL ashes that are incompatible with the radio transmission
wireless function.
Note:
1) When using E3
+
receiver as slave unit, restrictions will apply to parts of its
functions. And parts of the operations would also be different. For details, see
the instruction manual of E3
+
receiver
2) When performing radio transmission wireless ash shooting, restrictions
may apply to the ash mode, maximum ash sync speed (referred to below
as the “ash sync speed”) and high-speed sync function, depending on the
camera that you use.
Wireless Settings
To perform wireless shooting, set the E3
+
transmitter (master unit) and ash
(slave unit) with the following procedure.
1. Master unit setting: Check that
is displayed.
2. Slave unit setting: For the slave unit setting, see the ash or receiver’s
instruction manual.
To Next Page
Loading...
