AODELAN E3+ - 3 Using Fully Automatic Wireless Flash

24
When the recycling of all the ash units is completed, the master units’
charge lamp lights on.
1.6 Check the operation: Press the master unit’s test ash button (charge
lamp). The slave unit ash will re. If not, check that it is placed within the
operation range.
1.7 Take the picture: Set the camera and take the picture, in the same way
as with normal ash shooting. If a standard ash exposure was obtained,
the ash exposure conrmation lamp lights up (blue) for 2 sec.
2. Autoash Shooting Using Multiple Slave Unit
When you need more ash output or you want to perform lighting more
easily, you can increase the number of slave units and re them as a single
ash. To add slave units, use the same procedure as “ Autoash Shooting
Using One Slave Unit”. Set A, B or C as the ring group. The ash will not
re if it is set to D or E. When the number of the slave units is increased,
automatic control is performed to re all ashes at the same ash output and
ensure that the total ash output results in standard exposure.
Using Fully Automatic Wireless Flash
Flash exposure compensation and other settings set on the E3
+
transmitter
(master unit) will be automatically set in the ash (slave). You don’t need to
operate the slave unit.