25
1. Flash Exposure Compensation
In the same way as normal exposure compensation, you can set exposure
compensation for ash. The ash exposure compensation amount can be
set up to ±3 stops in 1/3-stop increments.
1.1 Press function button 4 until
is displayed.
1.2 Press function button 2 corresponding to
, is displayed
and ash compensation amount is highlighted.
1.3 Set the ash compensation amount: Turn<
> to set the ash
compensation amount, and press <
>button.
1.4 ”0.3” indicates 1/3 stops, and”0.7”indicates 2/3 stops.
1.5 To cancel ash exposure compensation, return the compensation
amount to “±0”.
Note:
1) By setting C.Fn13, you can choose to set the ash compensation
amount by turning <
> only, without operating function button 2
.
To Next Page
Loading...
