AODELAN E3+ - Flash Function Settings Overview

40
6. Take the pictures
Check that the <
> lamp of the master unit lights green and take the
picture. The slave unit cameras are released in coordination with the master
unit camera. After shooting with linked shooting, the < > lamp of slave
unit briey lights orange.
7. Press function button 1 corresponding to
on master unit will
release the shutter of all slave unit cameras.
Noted:
1.When using the linked shooting function, the slave unit camera might
need a shutter release cable(available separately) depending on the
camera models.
1) EOS digital cameras since 2012 (excluding EOS 1200D) do not
need to use shutter release cable.
2) EOS cameras before 2012, which are compatible with E-TTL II/E-TTL
autoash and come with N3 type remote terminal EOS, shutter release
cable will be needed for linked shooting.
2. Shooting with manual focus is recommended for the slave unit cameras.
If focus cannot be achieved with autofocus, linked shooting is not possible
with the corresponding slave unit cameras.