Before using this vehicle, the operator should always perform the following
pre-drive inspection check list.
Pre-Drive Inspection Check List
What to Do Before Starting the Engine (Key OFF)
Check for any leaks under vehicle.
Activate throttle lever several times to ensure it
operates freely. It must return to idle position when
released.
Apply parking brake and check if it operates
properly.
Check tire pressure and condition.
-Front: 97kPa(14 PSI)
-Rear:124kPa(18 PSI)
Check wheels for damage and for abnormal
play, and check lug nuts are tightened. Tighten
wheel bead lock bolts (if equipped).
Check cleanliness of the radiator.
Check drive shaft boots and protectors condition.
Check seat belts for any damage. Fasten seat
belts and confirm that they latch securely.
If you transport a cargo, respect the load capacity.
Ensure cargo is properly secured to the rear cargo
area.
If you are pulling a trailer or an other equipment:
- Check hitch and trailer ball condition
- Respect the tongue capacity and towing capacity.
- Ensure trailer is properly secured to hitch.
Check if the cargo box is properly latched.
Check if tail gate is properly latched.
Check underneath vehicle for any debris on
chassis or suspension and clean them properly.
To Next Page
Loading...