Refer to SPECIFICATIONS for
capacity.
Start engine and let it idle for a few
minutes. Ensure oil filter area and oil
drain plug areas are not leaking.
Stop engine. Wait a while to allow
oil to flow down to the crankcase
then check oil level. Refill as
necessary. Dispose of oil as per
your local environmental regulations.
Spark Plugs
Access to Spark Plugs
1. Open cargo box.
Spark Plug Removal
Unplug spark plug cable.
NOTE: Spark plug removal
procedure is the same for both
cylinders.
Clean spark plug and cylinder head
with pressurized air.
CAUTION: Always wear safety
goggles when using pressurized air.
Unscrew spark plug completely then
remove it.
1. Spark plug
Spark Plug Installation
Prior to installation make sure that
contact surface of cylinder head and
spark plug is free of grime.
Using a feeler gauge, set the spark
plug gap.
Apply a small amount of copper
based anti seize lubricant over spark
plug threads.
Screw spark plug into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
To Next Page
Loading...