void strong acceleration and
deceleration (throttle should not
exceed3/4).
Avoid pulling a load Avoid high
speed cruising.
BASIC PROCEDURES
Starting the Engine
The shift lever must be set to PARK
or NEUTRAL.
NOTE: For your convenience, an
over drive mode allows the engine to
be started with the shift lever in any
position. Press and hold the brake
lever(s) or the brake pedal while
pressing the engine start button.
Insert the key into the ignition switch
and turn it.
Press the engine start button and
hold until the engine starts.
NOTE:
- If engine does not start after a few
seconds, do not hold the engine
start button more than 10 seconds.
- Check if fuel is empty.
-See an authorized AODES USA
Pick Up UTV dealer.
Release the engine start button
immediately when the engine has
started.
NOTE: If the battery is dead, engine
cannot be started. Have the battery
recharged or replaced.
Changing Gear Selection
Apply brakes and select the desired
shift lever position.
Release brakes.
NOTE: When changing gear
seduction, always completely stop
the vehicle and apply the brakes
prior to moving the shift lever.
Otherwise damage to the
transmission may occur.
Stopping the Engine
NOTE:
-Avoid parking on slope as the
vehicle may roll away.
-Always put the vehicle in PARK
when stopped or parked to prevent
rolling.
-Avoid parking in places where hot
parts can start a fire.
Release throttle and completely stop
the vehicle.
Set shift lever in PARK position.
Apply the parking brake.
To Next Page
Loading...