Push the emergency engine stop
switch to OFF position.
Turn key in ignition switch to OFF
position or use the vehicle
emergency stop switch to stop the
vehicle .
Engine Overheat
If engine overheats, try the following:
1.Check and clean radiator fins.
2.Check coolant level and refill if
possible
3.See an authorized AODES USA
Pick Up UTV dealer as soon as
possible.
The radiator can be very hot, wear
gloves before touching radiator.
CAUTION:
Reduce vehicle speed but
try to keep vehicle moving to supply
air to radiator. If engine is still
overheating after approximately one
minute, stop vehicle and set
transmission to PARK. Stop engine.
Place the ignition switch to ON
position (DO NOT RESTART
ENGINE YET).The radiator fan will
cool the radiator. Let engine cool
down. Check coolant level and refill if
possible.
Never refill cooling system when
engine is hot.
Post-Operation Care
When vehicle is used in salt-water
environment (beach area,
launching/loading boats etc.), rinsing
the vehicle with fresh water is
necessary to preserve vehicle and its
components. Metallic parts
lubrication is highly recommended.
This must be performed at the end of
each operating day.
When vehicle is operated in muddy
conditions, rinsing the vehicle is
recommended to preserve vehicle
and its components and to keep
lights clean.
NOTE: Never use the high pressure
washer to clean the vehicle USE
LOW PRESSURE ONLY (like a
garden hose). The high pressure can
cause electrical or mechanical
damages.
Storage
When a vehicle is not in use for more
than one month, proper storage is a
necessity. Do key parts maintenance
work according to MAINTENANCE
CHART.
To Next Page
Loading...