1. Remove the radiator cap by
applying. pressure and turning it
counterclockwise.
Then drain the antifreeze from the
engine.
Complete the radiator filling.
Check the level in the coolant
reservoir and refill if necessary
Run engine at idle with the radiator
cap off.
Slowly add coolant if necessary. At
this point, wait until engine reaches
normal operating temperature.
2.With vehicle on a level surface,
liquid should be between MIN. and
MAX. level marks of coolant
reservoir.
NOTE: When checking level at
temperature lower than 20ā (689F),
it may be slightly lower than MIN.
mark.
NOTE: Ensure coolant reservoir
hose is properly routed to avoid any
interference when closing cover.
Suspension Adjustment
Guidelines
Your vehicle handling and comfort
depend upon suspension
adjustments.
Suspension adjustment could affect
vehicle handling. Always take time to
familiarize yourself with the vehicle's
behavior after any suspension
adjustment has been made.
Choice of suspension adjustments
vary with vehicle load, personal
preference, driving speed and terrain
condition.
The best way to set up the
suspension, is to start from factory
settings, then customize each
adjustment one at a time.
Front and rear adjustments are
interrelated. It may be necessary to
readjust the rear shock absorbers
after adjusting front shock absorbers
for instance.
Test run the vehicle under the same
conditions; trail, speed, load, etc.
Change one adjustment and retest.
Proceed methodically until you are
satisfied.
To Next Page
Loading...