1.6.3 Install HDD Drive
Slide the hard drive into the drive cage and make sure you can drive screws
through the slots of the drive cage.
After the hard drive is xed with screws on its sides, replace the drive cage
into the chassis and x it to the chassis with a screw.
Connect the at ribbon cable and power cord to the hard drive.
Note: Before you install hard drive to the drive cage and chassis, make sure
the power supply has been installed.
1.6.4 Install Memory Module
If you have to install memory modules by yourself, you have to remove
the optical drive cage first because the on-board memory slots are only
accessible after the optical drive cage has been removed. The memory
module is built with a fool-proof notch. The notch makes sure that the
memory module will not be installed incorrectly. The notch should match
an extruding point of the memory socket. Press down the memory modules
into the slots and lock them onto the slots with the clasps on two sides of
the memory slots.
To Next Page
Loading...
Need help?
General
