AOpen B2945 - Disassemble the System; Remove Top Cover


1.6 Disassemble the System
A user can disassemble the system according to the following steps.
1.6.1 Remove Top Cover
A user can disassemble the upper case by removing the three screws on the
three sides of the rear panel.
Remove the screws fastening the top cover to the back panel of the system
unit.
Pull out the top cover horizontally toward the direction of the front panel
until the rear edge of the top cover is 2 cm (0.787 inch) from the rear panel.
Then, lift the top cover.
Front Panel