AP Diving APV200 - Fit New Blue Button Cap; Screw Cap Retainer onto Main Body; Fit New O-ring onto Inlet Stem

AP Diving Ltd. APV200 Inflator Maintenance Manual
Page 26 of 30
6.10 Fit new blue button cap
- Just push it on.
- Make sure there is no visible gap between the blue cap and the main body.
6.11 Screw cap retainer onto main body
- Screw clockwise.
- The retainer should be done up tight using a torque of 2 Nm, which is as tight as
possible using your fingers PLUS nipping it up with a suitable tool.
o Make sure not to damage the retainer in the process.
- If the retainer is not securely tightened there is a risk of it being lost over time, which
may result in catastrophic failure if unnoticed.
6.12 Fit new O-ring onto inlet stem
- This O-ring needs to be replaced during service.