AP Diving APV200 - Page 3

AP Diving Ltd. APV200 Inflator Maintenance Manual
Page 3 of 30
6.7 Fit new O-ring and mesh filter into direct feed body ..................................... 25!
6.8 Push direct feed body into main body ........................................................... 25!
6.9 Push direct feed button into direct feed body ............................................... 25!
6.10 Fit new blue button cap ............................................................................... 26!
6.11 Screw cap retainer onto main body ............................................................ 26!
6.12 Fit new O-ring onto inlet stem ..................................................................... 26!
6.13 Push inlet stem into main body and screw stem retainer on ...................... 27!
6.14 Refit steel pin (if fitted) that holds the pull cord to the dumping elbow ........ 27!
AP50 hose assembly .......................................................................................... 28!
6.15 Fit new O-ring inside snap connector body ................................................ 28!
6.16 Screw new Schraeder valve into snap connector body .............................. 28!
6.17 Push 4 ball bearings back into snap connector body ................................. 28!
6.18 Put spring onto snap connector body ......................................................... 29!
6.19 Push sliding collar onto snap connector body ............................................ 29!
6.20 Refit circlip onto snap connector body ........................................................ 29!
7. Testing Instructions ............................................................................ 30!
7.1 Test spring operation and hose sealing by pushing complete hose on and off
the Inflator unit .................................................................................................... 30!
7.2 Test for leaks and proper operation .............................................................. 30!