AP TC5-2V2SA - Page 13

To Next Page

To Previous Page

TC5-2V2SA.rev.05

TC5-2V2SA

and the letter "P".

For each additional probe connected to the controller:

n Press the push-button once again. If the probe is not defective, the

letters "PR#" (where # is the number of the input to which the probe

is connected) are displayed, alternating with the on/off state of the

probe and the temperature measured by the probe. If the probe is

defective, the letters "PR#" are displayed, alternating with the on/off

state of the probe and the letter "P".