E-ITN 10
Installation and service manual M2015/04b [EN]
Display 5 digits LCD + 2 special symbols
Protection against cheating mechanical seal with billing company label
continuous control, when thermal influence is detected, allocator is
switched to single-sensor mode (E-ITN 10.5x, 10.6, 10.7x)
Data reading visual
infra-red (E-ITN 10.6, 10.7x only)
Data backup daily backup of measured values including real time
Function control automatic, can be activated and controlled by user
Dimensions 97 x 37 x 23 mm
Power supply lithium battery 3,0 V
Material ABS / Al – F22
IP code IP 42
Conformity ČSN EN 834
Data available via infra-red
interface (for exact data structure
see manual for decoding software)
E-ITN 10.6
• reading date
• serial number
• date of billing period beginning
• value for the last billing period
• alphanumeric code for the last billing period
• month values in last 11 months
• average surroundings temperature for the last billing period
• number of measuring cycles in single-sensor mode for the last
billing period
• max. radiator temperature in last billing period
• day when the max. temperature was achieved
• min. radiator temperature in last billing period
• day when the min. temperature was achieved
E-ITN 10.71
• reading date
• serial number
• date of billing period beginning
• value for the last billing period
• alphanumeric code for the last billing period
• monthly values in last 11 months
• actual value
• max. radiator temperature in last 11 months
• min. radiator temperature in last 11 months
• average radiator temperature in last 11 months
• average surroundings temperature in last 11 months
• number of days in month when conditions for measuring were
fulfilled in last 11 months
7 / 39
To Next Page
Loading...
Need help?
General