5
C
ONNECTING EQUIPMENT AND POWER TO THE UPS
1. Connect equipment to the UPS (cables not included for XLJ/XLT/XLTW models).
2. Avoid using extension cords.
• 3000 VA XLJ/XLT/XLTW/XLI and 5000/6000 VA XLJ/XLT/XLTW models: Using a power
cord, plug the UPS into a two-pole, three-wire, grounded receptacle only.
• 5000/6000 VA XLJ and 6000 VA XLT models: To draw full power from the UPS have a
qualified electrician cut off the input plug and hardwire the UPS to the appropriate power
panel.
3. Turn on all connected equipment. To use the UPS as a master ON/OFF switch, ensure all
connected equipment is switched ON. The equipment will not be powered until the UPS is
turned on.
4. To power up the UPS press the
button on the front panel.
• The UPS battery charges when it is connected to utility power. The battery charges to 90%
capacity during the first three hours of normal operation. Do not expect full battery run
capability during this initial charge period.
5. For additional computer system security, install PowerChute
®
Business Edition Smart-UPS
monitoring software.
O
PTIONS
Refer to the APC Web site, www.apc.com
for available accessories.
External Battery Pack SURT192XLBP
Rail Kit SURTRK2
Isolation Transformer
Service Bypass Panel
To Next Page
Loading...
Need help?
General
