EasyManuals Logo

APC Smart-UPS 2200 Installation Guide

APC Smart-UPS 2200
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Installation Guide Smart-UPS
X
2000/2200/3000 XL Tower/Rack-Mount 4U
Important Safety Messages
Read the instructions carefully to become familiar with the equipment before trying to install, operate,
service or maintain it. The following special messages may appear throughout this manual or on the
equipment to warn of potential hazards or to call attention to information that clarifies or simplifies a
procedure.
The addition of this symbol to a Caution product safety label indicates that a hazard exists that can result in
injury and product damage if the instructions are not followed.
The following safety messages may appear throughout this manual to warn of potential hazards.
Safety and General Information
Inspect the package contents upon receipt. Notify the carrier and dealer if there is any
damage.
Read the Safety Guide supplied with this unit before installing the UPS.
Adhere to all local and national electrical codes.
This UPS is intended for indoor use only.
Do not operate this UPS in direct sunlight, in contact with fluids, or where there is excessive dust or
humidity.
Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.
The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated
ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten
battery life.
Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or extension cords.
The batteries are heavy. Remove the batteries prior to installing the UPS in a rack.
Always install external battery packs (XLBPs) at the bottom of the rack. The UPS must be installed
above the XLBPs.
The UPS display interface will recognize as many as 10 external battery packs connected to the UPS.
However there is no limit to the number of XLBPs that can be used with the UPS.
Refer to Specifications in the Operation manual for UPS and battery weight.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage and minor or
moderate injury.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, can result in equipment damage.

Other manuals for APC Smart-UPS 2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the APC Smart-UPS 2200 and is the answer not in the manual?

APC Smart-UPS 2200 Specifications

General IconGeneral
Nominal Output Voltage230V
Nominal Input Voltage230V
Rack Height2U
Input Voltage Range160 - 286 V
Waveform TypeSine wave
Interface PortUSB
Typical Recharge Time3 hours
Form FactorRackmount/Tower
Frequency50/60 Hz
Battery TypeSealed Lead Acid (SLA)

Related product manuals