990-1048, Revision 1 12/00 6
4. Use the handles on the side of the UPS to sup-
port the unit.
Due to the weight of the UPS, two people are re-
quired to install it in the rack.
5. In four-post mounting each side of the UPS has a
cleat that must slide into the groove on the rails.
Slide the UPS into position.
6. Use the four ornamental screws supplied with the
UPS to attach the mounting brackets to the rack
post in both two and four post mounting.
Check the rack to make sure it will not tip after loading the UPS into the rack.
Reinstalling the Battery
If you removed the battery before mounting the UPS in
the rack, follow this step to reinstall it.
Supporting the battery on the bottom, align it with the
battery door opening and slide it into the compartment.
C
ONNECTING THE BATTERY AND ATTACHING THE FRONT BEZEL
0
|
The battery is accessible from the front of the UPS.
This procedure requires a Phillips head screwdriver.
1. Use a screwdriver to remove the two battery door
screws and open the door.
2. Locate the battery cables tucked on top of the bat-
tery.
3. Locate the UPS battery connector jack to the
right of the battery tray.
4. To connect the battery cable plug to the battery
jack, push the plug into the jack so the metal
pieces inside each part are touching. Press firmly
to ensure a tight connection. You will hear a
“snap” when the connector is seated properly.
5. Tuck the white cord and the battery cables into the
space above the UPS battery.
6. Close the battery door and replace the screws.
To Next Page
Loading...
