5 990-1048, Revision 1 12/00
Removing the Battery
The battery is accessible from the front of the UPS. This
procedure requires a Phillips head screwdriver.
1. Use a screwdriver to remove the two battery door
screws and open the door (hinged panel).
2. The battery is disconnected for shipment.
3. To disconnect the battery, take out the white cord that
is tucked into the space above the battery . This cord
serves as a handle for the connector plug.
4. Be careful during this step—the battery is heavy.
Pull the battery out of the UPS by pulling the clear la-
bel , not the white cord. (The battery consists of a
string of four batteries. The white cord is connected to
the battery leads, not the body of the battery.)
Mounting the UPS in a Rack
1. Install the mounting rails in the rack (required for
four-post racks only). Directions are included with the
rail kit.
2. For a four-post rack, attach a mounting cleat to each
side of the UPS.
3. Attach the mounting brackets to the UPS before
mounting the UPS in your rack, (below). Each mount-
ing bracket attaches to the UPS with four screws (in-
cluded). Two sets of bracket holes are located on the
sides of the UPS.
If you are using a four-post rack, attach the mounting
brackets in the forward position. For two post rack
mounting attach the brackets at the mid-point posi-
tion.
Four-Post Rack Two-Post Rack
Bracket Position Bracket Position
To Next Page
Loading...
