990-1048, Revision 1 12/00 4
S
TACKING THE UPS ON A BATTERY PACK
Note: For rack mounting, proceed to Mounting the UPS in a Rack, below.
1. Unpack the four mounting feet shipped in the mounting kit.
2. Turn the UPS on its side so the bottom surface is accessible.
3. Locate the indentations on the bottom of the UPS that mark
the feet positions (indicated by arrows in the figure at left).
4. Peel away the protective film on the back of one foot, align
the adhesive side with an indentation on the UPS, and press
hard to affix the foot to the UPS. Repeat this step for all feet.
0
|
B atte ry
Pack
5. Turn the UPS right side up and place it either on the floor on
an optional battery pack (shown). The battery pack cover has
indentations to accommodate the feet on the bottom of either
a UPS or another battery pack.
Do not step on the UPS. The UPS chassis is not designed to
support additional weight.
6. Continue with Connecting the Battery and Attaching the
Front Bezel, to complete the installation.
M
OUNTING THE UPS IN A RACK
The UPS comes with standard 19-inch (46.5 cm) rack mounting rails, brackets, and cleats. The rack
can have any of the common types of equipment mounting holes (square, round-threaded, or round-
non-threaded). All necessary hardware is provided.
The UPS is heavy. To lighten it, you may remove the battery before mounting the unit in the rack. If
you do not want to remove the battery, continue with Mounting the UPS in a Rack (next page).
To Next Page
Loading...
