To Next Page

To Previous Page

- 3 -

7.7 Conductivity probe maintenance ................................................................................. - 26 -

8 Parameter setting .............................................................................................................. - 27 -

8.1 Main menu and submenu ........................................................................................... - 27 -

8.2 Operation .................................................................................................................... - 27 -

8.3 Content of parameter setting ....................................................................................... - 28 -

9 USB communication .......................................................................................................... - 29 -

9.1 Install Software ........................................................................................................... - 29 -

9.2 Software Interface ....................................................................................................... - 29 -

9.3 Operation Keys of PC-Link.......................................................................................... - 29 -

10 Recommended pH Electrodes for Specific Applications.................................................. - 30 -

11 Recommended Conductivity Electrodes for Specific Applications ................................... - 31 -

12 Warranty ......................................................................................................................... - 31 -

Notes

• When the meter is connected to PC, do not pull out the USB cable until the

meter is turned off. Otherwise a system crash could occur. To fix the crash, pull

out the power cord, put it back in, and reboot the meter.

• Please do NOT pull out the power cord when the meter is turned on.

Apera Instruments PH910 User Manual

Questions and Answers: