EasyManuals Logo

Apollo XP95 Installation Guide

Apollo XP95
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
MAINTENANCE INFORMATION
Replacement Units
If any part of the beam detector set needs to be
replaced for reasons of damage or malfunction, the
transmitter, receiver and interface can all be ordered
separately.
As a result of product enhancements, however, some
older issues of interface or receiver are not compatible
with new units and it is not possible to replace older
versions with the enhanced version separately. In such
cases, both interface and receiver must be replaced if
a new receiver is to be installed.
The transmitter is not affected.
Fig 9 Issue number label– interface
Fig 10 Issue number label– receiver
Issue no
Issue No
Table 2 Compatibility table
Interface and receiver compatibility
Interface issue Receiver issue
1234
1 Yes Yes Yes No
2 Yes Yes Yes No
3 Yes Yes Yes No
4 & 5 Yes Yes Yes Yes
www.acornfiresecurity.com
www.acornfiresecurity.com

Other manuals for Apollo XP95

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Apollo XP95 and is the answer not in the manual?

Apollo XP95 Specifications

General IconGeneral
ColorWhite
Operating Voltage17V to 28V DC
Humidity0% to 95% RH (non-condensing)
TypeOptical Smoke Detector
ProtocolXP95 (Apollo Protocol)
CertificationEN54

Related product manuals