Apollo XP95 Installation Guide

2
XP95 BEAM DETECTOR
GENERAL INFORMATION
What is a beam detector? 4
How does a beam detector work? 4
Automatic reset 4
Automatic signal strength 4
SYSTEM DESIGN
Positioning beam detectors 4
How many XP95 beam detectors can be connected to a loop? 5
INSTALLING BEAM DETECTORS
Installation of interface 6
Setting the obscuration level 6
Setting the ‘total obscuration’ signal 6
Setting the address 7
Address settings 7
Installing transmitter and receiver 8
Retro operation 9
Alignment and calibration 9
Aligning the beam detector 10
Calibrating the beam detector 10
Notes 14
COMMISSIONING TESTS
1. Alarm test using fi lter 14
2. Total obscuration test 14
3. Response to protocol commands 14
MAINTENANCE INFORMATION
Replacement Units 15
Interface and receiver compatibility 15
TROUBLESHOOTING
Fault fi nding 16
TECHNICAL DATA
Spare parts 17
www.acornfiresecurity.com
www.acornfiresecurity.com

Apollo XP95 Specifications

General

Color	White
Operating Voltage	17V to 28V DC
Humidity	0% to 95% RH (non-condensing)
Type	Optical Smoke Detector
Protocol	XP95 (Apollo Protocol)
Certification	EN54