COMPOSERS:
1.) Press to view the composers on the iPod.
2.) Select the composer to view a list of songs
by that composer.
3.) Select the song from the list to begin
the playback.
AUDIO BOOKS:
1.) Press to view the audio books on the iPod.
2.) Select the audio book from the list to begin
the playback.
When an iPhone or iPod touch with iOS lower
than iOS 5.0 is connected through USB and
Bluetooth, the audio may not be heard when
the iPod source is selected. To correct this
situation, check the cable connection to the
dock connector on the iPhone or iPod touch
or disconnect and reconnect the Apple device.
Note: iOS is the Apple Operative System.
Use the following controls to play the iPod:
PREV (PREVIOUS)
Press PREV to seek to the beginning of the
current or previous track.
If the track has been playing for less than ten
seconds, it seeks to the previous track. If longer
than ten seconds, the current track starts from
the beginning.
NEXT (NEXT)
Press to seek to the next track.
FF/FR (FAST FORWARD/FAST REVERSE)
To fast forward or reverse through a track, press
and hold NEXT or PREV button.
RDM (RANDOM)
Press RDM to play the tracks randomly. Press
again to stop random (shuffle) mode. Look for
the RDM icon on the radio display when this
function is active.
RPT (REPEAT)
Press RPT to repeat current track. Press again
to stop repeat. Look for the RPT icon on the
radio display when this function is active.
ERROR MESSAGES
If an “UNSUPPORTED” message is displayed,
it could be for one of the following reasons:
• The iPod connected is not supported.
See page 9 for the iPod
models supported.
• The iPod does not respond to the radio
commands, in this case reset the iPod
and try
the connection again.
If a “NO MUSIC” message is displayed, it could
be for the following reason:
• There are not playable files on the iPod.
USB (IF SUPPORTED)
PLAYING FROM A USB
A USB storage device can be connected to the
USB port. The USB port is located on the front
of the radio.
Five volts DC power is limited to 2.1 amp from
this port. Some models are limited to 1 amp.
USB MP3 PLAYER AND USB
DRIVES
Any USB MP3 player or USB drive connected
to the radio must comply with the following
USB storage specifications:
• MS-Dos partition only.
• Class specification (USB MSC) and supports
formats of FAT32, FAT16, NTFS, and HFS+.
• Hard disk drives may be played, but they are
not supported.
• The radio will not be able to playback
write-protected music.
• MTP players are not supported.
• USB 3.0 devices are supported however
cannot be guaranteed for media playback
(unless backwards
compatibility is supported
by device).
PAGE 11
To Next Page
Loading...
Need help?
General
