If set to AUTO, the radio will:
• Execute Seek when the NEXT or PREV
buttons are short pressed.
• Execute Manual Tuning when the NEXT
or PREV buttons are long pressed
MANUAL TUNING
The current frequency will be increased or
decreased by 1 step of 0.2MHz (USA FM mode),
10 kHz (USA AM mode) and one channel
(25 kHz) in WX mode.
SEEKING A STATION
When the Seek function is activated the radio
increments/decrements the frequency until a
tunable station is found. If a tunable station is
not found the radio will display
‘NO STATION FOUND.’
PRESETS
STORING RADIO STATION PRESETS
Short press any of the Preset (1-6) buttons.
The frequency stored at the preset location is
tuned when the button is released.
SCAN
To initiate the Scan function, short press the
SCAN/ASCN button. When SCAN is initiated,
the radio seeks up in frequency and stops on
the next strong frequency for 8 seconds before
continuing to seek for the next strong station.
If no station is found in two passes through the
band, the radio will display ‘NO STATION
FOUND’ and returns to its initial frequency.
AUTOSCAN
This function temporarily stores the strongest six
stations of the current band in the presets until
the radio is powered off or the source is changed.
AUTOSCAN does not store the frequencies on
the presets in numerical order; they are stored
based on the order in which they were found
and on the quality of the frequency.
To initiate the AUTOSCAN function, long press
the SCN/ASCN button until the radio beeps;
then the ‘AUTO SCAN’ icon will blink while
the radio is storing the temporary presets.
When the storing process finishes the radio will
tune to the station stored in Preset 1 and the
‘AUTO SCAN’ icon shall be illuminated while
the mode is active.
To tune any of the six frequencies or to store
new presets follow the steps defined in the
Presets section.
To exit this mode and return to the original
presets execute any of the following actions:
• Press and hold the
SCAN/ASCAN button.
• Press the SRC button.
• Turn off the radio.
• Make an ignition cycle.
• Disconnect the battery.
WX
The WX band is for the Governmental weather
radio services frequencies; the radio can tune
the seven weather channels following the steps
in Tuning, Presets and SCAN sections.
LW
The Long Wave radio is mostly used in Europe.
You can navigate from 153 KHz to 279 KHz of
frequency. The steps between next or previous
channels is of 9 KHz. To navigate in LW follow
the steps in Tuning, Presets and SCAN sections.
SXM (IF SUPPORTED)
Vehicles with a valid SiriusXM
®
satellite
radio subscription can receive SXM
programming. SiriusXM has a wide variety
of programs and commercial-free music,
coast-to-coast and in digital-quality sound.
PAGE 6
To Next Page
Loading...
Need help?
General
