available when the radio is in AM/FM /LW
source (SRC) mode and (if supported) when the
radio is in SXM source (SRC) mode.
Additional setting adjustment Menus when
radio is in AM/FM/WX/LW Source (SRC) Mode:
• SEEK SENSITIVITY
• TUNE CONFIG
Additional setting adjustment Menus
when radio is in SXM Source (SRC) Mode
(if supported):
• CAT E/D (Category Enable/Disable)
• TUNE START
All of the setting adjustment Menus are defined
in the following sections of this manual.
AUDIO CONTROLS
Press the Volume Knob for more than two
seconds to access the Audio Controls Menu
from the scrolling list of setting adjustments
Menus. Press the Volume Knob again to enter
the Audio Controls Menu.
In the Audio Controls Menu you can adjust the
auto EQ, bass, middle, treble, fade, and balance
by rotating the Volume Knob until the desired
submenu is displayed. Press the Volume Knob
to select a submenu.
AUTO EQ:
The display will show the
current selected EQ option. Rotate the
Volume Knob clockwise and counterclock-
wise to cycle through Auto EQ options from
1 to 7. Select option, press the Volume Knob
to set. Options are:
1.) CLASSIC
2.) MANUAL
3.) POP
4.) ROCK
5.) COUNTRY
6.) NEWS
7.) JAZZ
BASS:
The display will show BASS and its
current level from -6 to +6. Rotate the Volume
Knob clockwise to increase the bass and
counterclockwise to decrease it. Press the
Volume Knob to set.
MIDDLE:
The display will show MIDDLE and
its current level
from -6 to +6. Rotate the
Volume Knob clock
wise to increase the middle
and counterclockwise
to decrease it. Press the
Volume Knob to set.
TREBLE:
The display will show TREBLE and
its current level
from -6 to +6. Rotate the
Volume Knob clockwise to increase the treble
and counterclockwise to decrease it. Press the
Volume Knob to set.
FADE:
The display will show FADE and its
current level from L15 to R15. Rotate the
Volume Knob clockwise move the sound to
the front speakers and counterclockwise to
move the sound to the rear
speakers.
Press
the Volume Knob to set.
NOTE: Fade is not
available in 2-speaker mode.
BALANCE:
The display will show BALANCE
and its current level from L15 to R15. Rotate
the Volume Knob clockwise move the sound
to the right speakers and counterclockwise to
move the sound to the left
speakers.
Press the
Volume Knob to set.
SPEAKERS (IF SUPPORTED)
Press the Volume Knob for more than two
seconds to access the Speakers Menu
from the scrolling list of setting adjustments
Menus. Press the Volume Knob again to enter
the Speakers submenu. The display will show
SPEAKERS and the current selected option.
The submenu allows you to change the speakers
between 2 and 4 Channels. Rotate the Volume
Knob to change between 2CH or 4CH and press
the Volume Knob to set.
PAGE 17
To Next Page
Loading...
Need help?
General
