When BT devices were previously paired the
Phone icon will be active and the Arrow icons
will blink until the reconnection of the
previously paired phone is attempted (each
phone reconnection will be attempted 3 times).
PAIRING A BLUETOOTH DEVICE
To complete pairing a BT device to the radio
the following steps must be followed:
‘Enable Bluetooth’ on the radio and on your BT
device. Refer to your device’s user guide for
more information.
Pair a BT device to the radio:
• Press the Phone button. The Bluetooth Menu
will be shown.
• Rotate the Volume Knob until the display
shows: ADD PHONE.
• Press the Volume Knob to confirm the action.
The radio will display ADDING PH for 3 seconds.
In this discoverable mode, the Bluetooth status
icon will blink for up to 3 minutes. If no phone
was found, the radio will display NO PH FOUND
and the Phone and Arrows icons will be disabled.
• During the discoverable mode set your cellular
phone to add a Bluetooth device and look for
the name “DEA700.”
Follow the instructions on your phone to add a
BT connection. When necessary, use the 4-digit
PIN ‘0000’ to connect to the radio.
When the cellular phone has been successfully
added, the radio will display PH CONNECTED
and then the Bluetooth device’s name. The
Phone icon will be active on the display, and
the Arrows icon will be disabled.
When the radio connects, the Bluetooth icon
will blink. The blinking icon signifies that the
radio is attempting to download the cellular
phone’s CONTACTS (for the DIAL CONTACTS
function). The icon will cease to blink if all
contacts have been downloaded or if the radio
times out from receiving contacts from the
cellular phone. See your phone’s user guide for
information. See Notes 1, 2 and 4 in this manual.
NOTE: While in pairing mode, changing the
‘source’ will cancel this process. The source can
be changed from the SRC button on the radio
or from external controls (steering wheel or rear
seat audio control).
CONNECTING A BLUETOOTH DEVICE
If your BT device was previously paired, you can
connect the device to the radio easily:
• Press the Phone button. The Bluetooth Menu
will be shown.
• Rotate the Volume Knob until the display
shows CONNECT PH.
• Press the Volume Knob to confirm the action.
• Select the desired BT device (rotate the
Volume Knob to locate device name and
confirm selection by pressing in the Volume
Knob). The radio will show CONNECTING
for 3 seconds.
• When the radio connects the BT device, the
radio will display PH CONNECTED and the
name of the device, the Bluetooth icon will blink.
The blinking BT icon signifies that the radio is
attempting to download the device’s (cellular
phone) CONTACTS (for the DIAL CONTACTS
function). The icon will cease to blink if all
contacts have been downloaded or if the radio
times out from receiving contacts from the
cellular phone. The Phone icon will be active
on the radio display.
DUAL PHONES
This feature gives you the ability to have two
connected Bluetooth devices paired to the
radio at the same time; one as a phone and
another as the Bluetooth media device. In order
to use this feature the two BT devices must be
in range of the radio to be paired. Use ‘Manual’
selection of the BT devices in the Phone Menu
to connect the desired phone on the proper
profile (Phone or Audio).
PAGE 13
To Next Page
Loading...
Need help?
General
