10-02-2020 Page 30 of 32 ARB Copyright 2017 3789736
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
OVER-RAIL TAILGATE LINER – IF SUPPLIED
6.32) Apply masking tape to the inside top edge of the
tailgate liner.
6.33) Mark a line across the width of the tailgate liner
12mm down from the top of the tailgate.
6.34) Cut the top lip off the tailgate liner using a jig saw
and sand the edge.
6.35) It may be also required to trim the side edge of
the liner to make a neat appearance as shown at
the arrow.
6.36) Then fit the tailgate liner as per the bed liner fitting
instructions.
To Next Page
Loading...
