Need help?Do you have a question about the ARB LINX LX100 and is the answer not in the manual?
General| Brand | ARB |
|---|---|
| Model | LINX LX100 |
| Category | Automobile Accessories |
| Language | English |
Details the components included in the LINX kit for setup and initial use.
Lists ARB accessories that can be controlled and monitored by LINX.
Describes additional products available to complement the LINX Vehicle Accessory Interface.
Guides on connecting and configuring LINX accessories and the system.
Explains how to power the LINX Display and its initial operation.
Instructions for powering the LINX Display on and off.
Process for checking and installing LINX software updates.
Steps for pairing the LINX Display and Controller via Bluetooth.
Overview of the LINX Display interface, its features, and specifications.
Describes the ARB LINX home screen and its status bar icons.
Explains how to access and use Quick Settings and Main Settings menus.
Details basic interaction methods like tap, double tap, press & hold, and swipes.
Illustrates different screen layouts: Main Icon, Split, Full Screen, and Text Entry.
Explains the main icon screen for accessing modules, settings, and system information.
How to access individual modules and return to the main icon screen.
Details settings for Auto Night Mode, Units, Theme Colour, and Vehicle Calibration.
Steps to update LINX software and controller firmware.
Control and setup Air Lockers, automatically turn on the air compressor.
Configure Traction modules for 'front axle second' or 'front independent of rear' modes.
Configure and operate the air compressor; optional Pressure Control for tyre inflation/deflation.
Set compressor parameters like 'Disable When Engine OFF' and 'Maximum System Pressure'.
Activate optional Pressure Control and set target pressure for inflating tyres.
Select from 3 pressure control modes: Off, Control, or Max.
Control up to six accessories, customize switching, and set low voltage cut out.
Activate accessories, set automation, and configure low battery protection.
Assign custom names to accessories for easier identification.
Automate accessory switching based on vehicle inputs like high beams.
Assign protection to switch off accessories when battery level drops.
Monitor and display the charge state of up to three independent batteries.
Activate batteries and set low voltage alarm levels.
Assign custom names to batteries for clarity.
Set the voltage threshold that triggers a low voltage alarm.
Show vehicle speed, altitude, and bearing using GPS.
Configure the speedometer display.
Set a speed limit to receive a warning when exceeded.
Control up to 4 airbags for leveling and managing uneven loads.
Set airbag control modes, pressure limits, and custom names for modes.
Assign custom names to air suspension modes.
Adjust individual airbag pressures or change preset modes.
Monitor and display vehicle roll and pitch, with alarm warnings.
Configure roll/pitch limits, audible alarms, and display settings.
Set and manage roll/pitch limit alarms, with visual and audible alerts.
Access time functions like local/world time, timer, alarm, and stopwatch.
Set and use the timer with start and audible notification.
Set alarm times, snooze, and enable/disable alarms.
Start, stop, and reset the stopwatch.
Select and display time from different time zones.
Provides EU conformity declaration and lists applicable standards and directives.
Details FCC compliance, conditions for operation, and potential interference.
Guidance on proper disposal of waste electrical products.
To Next Page
