PAGE 42
LOW BATTERY PROTECTION
To assign Low Battery Protection to switch off the 'INTENSITYS AR32' based on
Battery 1’s set Low Voltage Alarm level:
Tap the Battery 1 button to activate it.
(Refer to the section on the Battery module for
customising the battery settings and entering a
Low Voltage Alarm level)
NOTES
• In the example shown above, the Low Battery Protection on Battery 1 will ensure that the 'INTENSITYS AR32' are
switched off (even though your high beam lamps are still switched on) once the battery level drops below limit set
by Low Voltage Alarm in the Battery module settings.
• All automation functions are user over-ridable. In the example above, LINX will automate the 'INTENSITYS AR32' to
come on whenever the high beams are activated, but the 'INTENSITYS AR32' can still be switched off by the user at
any time.
SWITCHING ON AN ACCESSORY
To switch the accessory on, tap the button once. Tap again to switch off.
To Next Page
Loading...
Need help?
General
