PAGE 16
UPDATING LINX SOFTWARE
Once the LINX Controller has been connected to power it is important to check for
and perform a LINX software update before doing any further wiring.
To do this, you will need to turn on the LINX Display, connect to the internet (via
wi for mobile data) and then connect to the LINX Controller using the provided
USB cable.
The LINX Display may take up to 1 minute to turn on and start the LINX App. When it
starts you may briey see the ‘connecting screen’ shown below.
When the LINX Display and LINX Controller
are connected, the display should
change to ‘split screen mode’, displaying
Speedometer module and Battery module
which are activated by default.
Swipe from left to right across the screen to show the
LINX Main Icon Screen. Then tap on the settings icon.
The settings page will be displayed. Tap
LINX Update.
To Next Page
Loading...
Need help?
General
