PAGE 47
SETTING SPEED LIMIT WARNING
To set the speed limit:
1. Press & hold the underlined value (“0 km/h”) next to Speed Limit Warning to
bring up the keypad entry.
2. Use the keypad to input the required
value, then select the tick to set it.
1. Tap the tick box in the top right corner to
activate the Speed Limit Warning.
2. Tap the BACK to return to Speedometer
module screen.
LINX will now monitor the vehicles’ speed and let the
driver know when the limit has been exceeded by
changing the displayed speed colour to RED.
NOTES
• Parameters that may be set by the user are shown underlined (e.g. Speed Limit Warning value).
• Theme coloured parameters (e.g. Altitude, Bearing and Speed) are monitored by the system.
• The GPS in your LINX Display requires good outdoor signal reception from at least three satellites to pinpoint your
location for accuracy of operation. Greyed-out values indicate no GPS reception and are not real time (e.g. When
driving through a tunnel).
To Next Page
Loading...
Need help?
General
