SWITCHBOARD
MODULE
The LINX Switchboard module can be used to control up to six (6)
optional switched accessories connected to your LINX Controller.
Each accessory can be given a unique name (up to 16 characters) and then be
customised to switch on or off; by user input, or an one of the 'vehicle inputs':
accessory power, parker/low beam headlamps, high beam headlamps or reverse
lamp.
They can also be turned off automatically when a user dened setting for low
voltage cut out has been detected by LINX to protect your vehicle from a at
battery. All settings are saved back to the LINX Controller and remain active 24/7
even if the LINX Display is off or is removed from the vehicle.
1. Press and hold on an individual accessory button
to show its settings page.
CONFIGURING SWITCHBOARD MODULE
2. Tap the checkbox in the right hand corner
to activate the accessory.
To Next Page
Loading...
Need help?
General
