EasyManuals Logo

Arcam AVR550 User Manual

Arcam AVR550
384 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
E-20
The universal remote controller
e Receiver is supplied with a sophisticated ‘universal’
backlit remote control that can control up to eight
devices. It is pre-programmed for use with the Receiver
and many other Arcam products (FM/DAB tuners, CD
players and DVD players).
With its extensive built-in library of codes, it can also
be used with thousands of third party audio-visual
components – TVs, satellite and set-top boxes, PVRs,
CD players, etc. See the list of codes at the back of this
handbook, beginning on page 47.
It is also a ‘learning’ remote, so you can teach it almost
any function from an old single-device remote.
remote
control
Using the remote control
Please keep in mind the following when using the
remote control:
< Ensure there are no obstacles between the
remote control and the remote sensor on the
Receiver. e remote has a range of about 7
metres. (If the remote sensor is obscured, the Z1
IR remote control input jack on the rear panel is
available. Please consult your dealer for further
information.)
< Remote operation may become unreliable if
strong sunlight or uorescent light is shining on
the remote sensor of the Receiver.
< Replace the batteries when you notice a
reduction in the operating range of the remote
control.
Notes on batteries:
< Incorrect use of batteries can result in hazards such
as leakage and bursting.
< Do not mix old and new batteries together.
< Do not use non-identical batteries together –
although they may look similar, dierent batteries
may have dierent voltages.
< Ensure the plus (+) and minus (-) ends of each
battery match the direction indicated in the battery
compartment.
< Remove batteries from equipment that is not going
to be used for a month or more.
< When disposing of used batteries, please comply
with governmental or local regulations that apply in
your country or area.
Inserting batteries into the
remote control
1. Open the battery compartment on the back of
the handset, by sliding its cover o.
2. Insert two ‘AAA’ batteries, as indicated in the
battery compartment.
3. Slide the battery compartment cover back rmly
into its locked position with a click.

Table of Contents

Other manuals for Arcam AVR550

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Arcam AVR550 and is the answer not in the manual?

Arcam AVR550 Specifications

General IconGeneral
Receiver typeSurround
Frequency range20 - 20000 Hz
Audio output channels7.1 channels
Signal-to-Noise Ratio (SNR)110 dB
Power output per channel (20-20KHz@8 Ohm)- W
HDMI in7
Ethernet LAN (RJ-45) ports1
Number of HDMI outputs3
AirPlayNo
Audio decodersDTS-ES (Discrete 6.1), DTS-ES (Matrix 6.1), DTS-HD Master Audio
Audio Return Channel (ARC)Yes
Apple docking compatibilityNot supported
Power consumption (standby)0.5 W
Power consumption (typical)1500 W
Supported radio bandsDAB, DAB+, FM
Internet radio services supportedSpotify
12V trigger ports quantity2
Speakers connectivity type-
Package weight18800 g
Weight and Dimensions IconWeight and Dimensions
Depth425 mm
Width433 mm
Height171 mm
Weight15500 g

Related product manuals