EasyManua.ls Logo

arcelik 6233 - Combined Tablet Detergents

arcelik 6233
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Dishwasher / User’s Manual
17 / 48
EN
Preparation
by pressing on it lightly. A “click” will
be heard when the lid is closed.
C
In programmes with prewash
and high temperature,
in which you use tablet
detergents, make sure that
the detergent dispenser lid is
closed firmly.
C
Use powder detergent in
short programmes without
prewash since the solubility
of the tablet detergent
changes depending on the
temperature and time.
A
Excessive usage of powder
detergents will cause the
detergent not dissolve
completely and will also
cause scratches on the
glassware.

Combined tablet detergents exhibit
water softening and / or rinse aid effect
in addition to detergent effect. Some
types of these detergents also contain
special-purpose washing chemicals
such as glass and stainless steel
protectors.
Combined tablet detergents are
available as 3in1, 5in1, Allin1 etc. They
function only up to a specific degree
of water hardness. Above this limit
regeneration salt and rinse aid must be
added. Refer to the instructions on the
packaging of the combined detergent
whether it is suitable for the hardness
level of the water supply.
C
While using combined tablet
detergents contact with the
detergent producers if the
dishes are wet and/or if
you notice limescale spots
particularly on glasses after
the washing programme is
over.
C
The best washing
performance in dishwashers
is obtained by using
detergent, rinse aid and
water softening salt
individually.
When you switch to powder, liquid/gel
or tablet detergent from a combined
tablet detergent:
1. Make sure that salt and rinse aid
reservoirs are full.
2. Set the water hardness to the
highest level and perform an empty
run.
3. After the empty washing cycle,
review the user manual and
readjust the water hardness level
so as to suit the water supply.
4. Make the appropriate rinse aid
settings.
C
Depending on the model,
salt indicator and/or rinse aid
indicator must be enabled
again if they were disabled
before.

Table of Contents

Related product manuals