Dishwasher / User’s Manual
13 / 48
EN
Preparation
C
You can put about 2 kg of
dishwasher salt into the salt
reservoir.
4. Replace the lid and tighten it
securely when the reservoir is full.
5. If you will not start a washing
programme immediately after
adding the salt, run the machine
empty in the shortest programme
to dissolve and wash away the
scattered salt in the machine.
C
Since different salt brands
in the market have different
particle sizes and since the
water hardness may vary,
dissolution of the salt in
water may take a couple
of hours. Therefore, Salt
Indicator remains on for a
while after adding salt into
the machine.
Loose salt grains can cause
rust marks in your machine
if not rinsed away. Only fill
salt just before a programme
is run.
C
Salt reservoir will fill with
water when you start the
product. Therefore, add the
softening salt before starting
the machine.
C
Before initial use, fill the
water softening system with
1 litre of water (C).
3. Fill the salt reservoir with salt by
using salt funnel (D). To speed up
dissolution rate of salt in water, stir
it with a spoon.
Cleaning, rinsing and drying
performance of your dishwasher will
increase when water softening system
is adjusted properly.
Adjust the new water hardness level
according to the Water hardness level
instruction in this booklet.
Use the test strip supplied with the
product according to the steps given
below to determine hardness level of
your supply water.
To Next Page
Loading...
