Dishwasher / User’s Manual
39 / 48
EN
Operating the product
Please check the Salt Indicator on the
panel to see whether there is adequate
amount of softening salt in the
dishwasher or not. You need to refill
the salt reservoir with salt whenever
salt warning indicator appears on the
panel of your machine.
Please check the Rinse Aid Indicator
on the panel to see whether there is
adequate amount of rinse aid in the
dishwasher or not. You need to refill
the rinse aid reservoir with rinse aid
whenever rinse aid warning indicator
appears on the panel of your machine.
When the programme you have
selected comes to an end, the End
progress indicator light will lights up.
1. Open the door of the dishwasher.
2. Turn off your machine.
3. Close the tap.
4. Unplug the machine from the
socket.
A
Leave your dishes in the
machine for about 15
minutes after they are
washed in order to have
them cooled down. Your
dishes will dry in a shorter
time if you leave the door of
your machine ajar during this
period. This will increase the
drying effectiveness of your
machine.
It is used to operate the machine
without loading it completely.
1. Load your dishes in the machine
using top and bottom baskets
2. Turn the machine on.
3. After selecting the desired
programme, press the Half Load
key. Half Load indicator lights up.
4. Close your machine’s door and
press Start / Stop key.
C
With the Half Load function
you can save both water and
power while using the lower
and upper baskets of the
machine.
C
Half Load function may
cause changes in the
programme duration.
To cancel a programme while the
machine is operating:
Press start/stop key for 3 seconds.
The machine will drain the water inside
the machine for 45 seconds. The
programme is cancelled when washing
light goes off. Then, you can choose
and start a new programme.
C
There might be residues of
detergent or rinse aid left
in the machine and / or on
the pieces being washed
depending on the step
the programme you have
cancelled was in.
To Next Page
Loading...
