Dishwasher / User’s Manual
37 / 48
EN
Operating the product
1. Open the tap.
2. Plug in to the socket.
3. Open the door of the dishwasher.
4. Place the dishes in accordance
with the instructions in the user
manual.
5. Make sure that the upper and lower
impellers rotate freely.
6. Put sufficient amount of detergent
in the detergent dispenser and
close its lid.
7. Check if the Salt and Rinse Aid
indicators light and add salt and /
or rinse aid if needed and close the
door of the machine.
9. Select the most suitable
programme by using the table of
“Programme Data and Average
Consumption Values”.
10. Select the desired programme with
Programme Selection key.
11. Start the programme by pressing
Start / Stop key.
C
Programme and auxiliary
functions cannot be
set/changed after the
programme has started.
C
Your machine performs
water softening depending
on the hardness level
of the supply water. The
total time can also change
while the programme is
running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the
dishes.
A
Pay attention not to open the
door of the machine when
it is running. If you need to
open the door, safety system
will stop your machine.
There may be a rush of
vapour when you open the
door of your machine; be
careful. Washing programme
will resume running when
you close the door.
To Next Page
Loading...
