To Next PageTo Next Page
Need help?Do you have a question about the Arcom RC210 and is the answer not in the manual?
General| Brand | Arcom |
|---|---|
| Model | RC210 |
| Category | Controller |
| Language | English |
Explains the three types of commands: Port Specific, Global, and Programming.
How the controller evaluates DTMF digits and the terminator digit.
How commands are protected and made accessible via unlock codes.
Commands affecting operating conditions, stored in non-volatile memory.
Commands controlling RC210 behavior, accessible when ports are unlocked.
8-channel ADC for measuring voltages, programmable for various sensors.
Program meter faces with names and scale values for A/D inputs.
Program high/low alarms on meter inputs to trigger Command Macros.
Enable, disable, or interrogate logic alarms triggered by input transitions.
Commands to control remote base radio frequency, offset, CTCSS, and mode.
Recall stored remote base radio configurations from internal memories.
Recall memories from specific Kenwood radios.
Select transmitter power for Kenwood or Doug Hall RBI-1.
Execute multiple functions, generate speech, send DTMF, remap functions.
Syntax for programming Command Macros with function numbers.
Long (1-40) up to 15 functions, Short (41-90) up to 4 functions.
Notes on function number limits and slot usage in macros.
Use macros to assign user-friendly codes to functions.
On-board DVR for custom messages, 63 seconds total, 20 tracks.
6 independent timers, programmable in seconds, run Command Macros on timeout.
Program 6 general timers to run macros on timeout.
Each port programmed individually; unlock code needed to program.
How to set and reprogram unlock codes for each port.
Program programmable hang time for port transmitters.
Set time-out timer to drop transmitter if signal exceeds duration.
Program the HH MM [SS] format for the real-time clock.
Program the MM DD YY format for the calendar.
Select the type of radio used as a remote base.
Program internal memories for recalling remote base settings.
Store and recall memories for Kenwood radios.
Create macros by defining functions and unique command codes.
Understand how Macro Functions and nested Macros are executed.
Run Command Macros based on receiver activity (active/inactive).
Specify which port(s) should receive speech announcements from macros.
List of Function Numbers (FN) and their corresponding descriptions.
Continuation of FN list, covering functions 119-251.
Continuation of FN list, covering functions 252-352.
Continuation of FN list, covering functions 353-459.
Continuation of FN list, covering functions 460-568.
Continuation of FN list, covering functions 569-701.
Program Tail Messages based on repeater tails or periodic timer.
Suspend IDs and Timeout Timer for special events.
Program setpoints to run macros at specific times/days.
Using scheduler for recurring messages and suspend/resume functionality.
Example of programming macros and setpoints for recurring tasks.
Record audio tracks (1-20) into the DVR.
Program high/low alarm trip points to run Command Macros.
Download and install the Arcom Updater software.
Connect cable and upload firmware update file to the RC210.
Quick reference for programming commands and their meanings.
Continuation of command codes and their meanings.
