Core Series Draining the Water
To Drain Your Core Spa:
1. Shut o the GFCI RCD breaker located in the sub panel or the quick disconnect.
2. Locate and remove the drain plug.
3. Thread your garden hose in the adapter.
4. When the Hose is threaded in, pull the hose and the drain will open and begin draining.
Custom Series Filtration System
Filter Cartridge Removal and Installation For Custom
1. Put the Spa in Standby mode using sds button on the
topside control panel.
2. Remove the telescoping lter Insert.
3. Remove Pre-Filter.
4. Grab handle and pull up sharply to remove lter cartridge.
5. Insert new Filter cartridge.
The use of Clariers and Foam inhibitors is not recommended
with disposable lters!
Arctic Spas
®
are equipped with balanced ltration, meaning that the lter cartridges are sized to
meet the needs of the pump system. As with any water ltering system, the lter cartridge may become clogged,
resulting in reduced water ow. It is important to maintain a clean, unobstructed lter system.
Classic and Core Series Filter Cartridge Removal and Installation
1. Put the spa in Standby mode using the on/o button on the topside control panel.
2. Remove the telescoping lter cylinder
3. Unscrew the lter cartridge and either clean the reusable lter or discard the disposable lter.
4. Re-thread the clean or new lter.
5. Slide the telescoping lter cylinder back into the lter bucket.
6. We recommend that your lter cartridge be replaced with an Arctic Pure
®
disposable lter cartridge
every three (3) months.
IMPORTANT: With reusable lters, it is necessary to rinse the lter cartridges weekly. Every
month, and each time the spa is drained for cleaning, clean the cartridges in lter cleaner. (With
Arctic Spas disposable lters, simply replace the cartridge whenever the spa is drained, or about every
three months).
1616
Owners Manual - Arctic Spas®
To Next Page
Loading...
Need help?
General
