Spa Functions
Off Mode
Pressing Pump 1 for 5 seconds will enable the O Mode. This
mode allows you to stop all outouts including automatic functions
such as lter cycle, heat request and smart winter mode for 30
minutes to perform quick spa maintance. When O Mode is active,
the display will toggle between the “OFF” message, the clock and
the water temperature. The spa light will ash for a few seconds
before the end of the 30 minutes to warn you that the system is
about to resume its normal operation.
Press Pump 1 or Pump 2 (if available) to restart the system before the expiration of the 30 minutes delay. When the
system resume its normal operation, the display shows “ON” for 3 seconds.
Pump 1
Press Pump 1 key to turn Pump 1 on at low speed. Press second
time to turn pump to high speed. A third time turns pump o. A
built-in timer automatically turns pump o after 20 minutes, unless
pump has been manually deactivated rst.
The “Pump 1” indicator lights up when Pump 1 in on. The indicator
will ash when pump 1 is on at low speed.
Pump 2 (Not available on all models)
Press Pump 2 key to turn Pump 2 on at high speed. Press a sec-
ond time turns pump o. A built-in timer automatically turns pump
o after 20 minutes, unless pump has been manually deactivated
rst.
The “Pump 2” indicator lights up when Pump 2 in on.
Owners Manual - Core Series
6161
To Next Page
Loading...
Need help?
General
