1.10.3 Program Filtration Cycles/Filtration Duration
The factory default ltration settings will automatically perform 4 x two-hour ltration cycles per day, 6 hours
apart. Depending of bather load and spa usage it is suggested ltration settings can be changed to automati-
cally perform 4 one- hour ltration cycles per day, 6 hours apart.
The system factory ltration settings can be adjusted by the consumer through:
• OnSpa® power management using your device such as smart phone or tablet that has been connected to
your spa through WiFi. Refer OnSpa® user Guide. (Pg.117)
1.10.4 Stabilize Spa Water
Before you attempt to balance the water, the water temperature must rst reach a minimum temperature of
85°F, (29°C).
Note: Do not be tempted to use your spa at this time.
Understanding Spa Boy®
Step to Stabilize Spa Water
Once the spa has been lled with water, powered up and ltration requirements set, place the insulated cover on
the spa and allow the water temperature to stabilize (approximately 16 hours). Make sure you secure the cover
in place using the cover locks. Periodically check the spa water temperature. When the water temperature climbs
above 85°F, (29°C) proceed to the next step.
Note: As heat impacts both Calcium and Total Alkalinity a little, it is highly recommended to heat the water above
29°C (85°F) before advancing to Establishing Correct Water Chemistry.
1.10.5 Establishing Correct Water Chemistry
The following steps provide guidance to help establish correct chemically balanced water. To help ensure chemi-
cals dissolve appropriately it is good practice to rst mix/dissolve the chemical in an uncontaminated container of
hot water before adding to the spa water.
Steps to Establish Chemically Balanced Water With Spa Boy
Step 1. Test and Adjust Total Alkalinity (Use drop Test Kit)
Test Total Alkalinity. It should be 80 – 100 ppm (100 max). If high, lower Total Alkalinity with
Arctic Pure, Salt Water Balance. Do not raise Total Alkalinity!
WARNING: Skipping this step on Start-up can cause scaling problems and cloudy water that may not be covered
under warranty.
NOTE: Use all products according to directions on the bottle.
Owners Manual - Spa Boy®
8282
To Next Page
Loading...
Need help?
General
