Arctic Spas Custom Series User Manual

1.10.2 Fill Spa With Water Power Up Spa and Set Water Temperature
The following steps provide guidance to help establish correct chemically balanced water. To help ensure
chemicals dissolve appropriately it is good practice to rst mix/dissolve the chemical in an uncontaminated
container of hot water before carefully adding to the spa water.
Note: The following steps take into account that the Spa Technician has lled your spa with water to above the
Spa Boy Sensor Housing, removed the Spa Boy Sensor Plug, installed the Spa Boy Sensor Housing Grate and
installed the Spa Boy Sensor.
Warning: Do not proceed until the Spa Technician has lled your spa with water to above the Spa Boy Sensor
Housing, removed the Spa Boy Housing Plug, installed the Spa Boy Sensor Housing Grate and installed the
Spa Boy Sensor or you have obtained further direction from your Dealer.
Spa Boy Owners Manual
Spa Boy Owners Manual Version 1 Revision 1 (R1)
Page 14 of 35 Issued 20 Nov 2014
1.14.2 FFiillll SSppaa WWiitthh WWaatteerr PPoowweerr UUpp SSppaa aanndd SSeett WWaatteerr
TTeemmppeerraattuurree
The following steps provide guidance to help establish correct chemically balanced water.
To help ensure chemicals dissolve appropriately it is good practice to first mix/dissolve the
chemical in an uncontaminated container of hot water before carefully adding to the spa
water.
Note: The following steps take into account that the Spa Technician has filled your spa
with water to above the Spa Boy Sensor Housing, removed the Spa Boy Sensor Plug,
installed the Spa Boy Sensor Housing Grate and installed the Spa Boy Sensor.
Warning: Do not proceed until the Spa Technician has filled your spa with water
to above the Spa Boy Sensor Housing, removed the Spa Boy Housing
Plug, installed the Spa Boy Sensor Housing Grate and installed the Spa
Boy Sensor. or you have obtained further direction from your Dealer.
Steps to Fill Spa With Water Power Up Spa and Set Water Temperature
Step 1. Fill Spa
Fill your spa through the filter intake as shown to the
appropriate level (just under the head rests). If you have
sediment or high mineral content a “carbon filled pre-filter”,
as pictured, can help. (This is optional and will prolong
the fill time).
Step 2. Connect/Turn on Electrical Power to the Spa
Once the spa is filled to the proper level, connect power to
the spa in accordance with the Arctic Spas Owners Manual,
and turn the power on to the spa on.
Understanding Spa Boy®
Steps to Fill Spa With Water Power Up Spa and Set Water Temperature
Step 2. Connect/Turn On Electrical Power To
The Spa
Once the spa is lled to the proper level, connect power to the spa
in accordance with the Arctic Spas Owners Manual, and turn the
power on to the spa on.
Step 3. Set Water Temperature
Set the water temperature control on the Topside Controller to
the desired temperature (between 100ºF and 104ºF or 38°C and
40°C).
Step 1. Fill Spa
Fill your spa through the lter intake as shown to the appropriate
level (just under the head rests). If you have sediment or high min-
eral content a “carbon lled pre-lter”, as pictured, can help. (This
is optional and will prolong the ll time).
Owners Manual - Spa Boy®
8181

Arctic Spas Custom Series Specifications

General

Brand	Arctic Spas
Model	Custom Series
Category	Hot Tub
Language	English