Startup Programming
Setting the Clock
Enter the program menu by holding down the Light key for 5
seconds. The display will show the current clock setting with
the hour ashing.
Depending on factory settings your system may be set
to 24-hour time or 12-hour time.
Setting the hour: Use the arrow keys to adjust the hour. Press the Light key to jump to the next parameter, the
minutes. Setting the minutes: Use the arrow keys to adjust the minutes. Press the Light key to jump to the next
parameter, the lter or purge start time (FS).
Programming the lter
The lter cycle menu consists of the following parameters: the start time (FS), the duration (Fd) and the frequency
(FF). A lter cycle consists of starting all the pumps in high speed for 1 minute (purge step) then, the pump associ-
ated with the lter will run in low speed for the remaining duration of the lter cycle (clean step).
Owners Manual - Core Series
6363
To Next Page
Loading...