Sub Steps to Help Ensure Sodium Chloride Test Strips are Used Correctly
Step 1. Take Water Sample
Take a sample of water from the spa in a small cup (about 25mm / 1”
full).
NOTE: Always take water samples 25-30cm (12”-18”) below the water
surface.
Step 2. Place Test Strip in Water Sample
Place the lower end of the strip into the water.
IMPORTANT Keep top half of strip COMPLETELY dry to get an ac-
curate reading.
Step 3. Test Duration Period
Leave strip in water for 3 – 5 minutes until yellow band at top of strip
turns dark.
Step 4. Obtain Readings
Obtain your reading: where top of white peak falls on the number
scale.
Read top of peak to the nearest 0.2 division.
Step 5. Correspond Test Result Reading
Correspond the test result reading number with the numbers on the
bottle.
Understanding Spa Boy®
Owners Manual - Spa Boy®
8484
To Next Page
Loading...
Need help?
General
