Arctiko LR170 - Reading Temperature Memory (Situation 1); Resetting Temperature Memory

- 8 -
Operation of the temperature memory in situation 1.
To read the stored maximum and minimum temperatures under normal conditions, please do as below:
When pushing the
button and keeping it pushed, the warmest temperature is presented. The display is now
showing the +5 °C. When releasing the button again, the display returns back to normal run. To read the coldest
temperature, use the
button. The display presents +2 °C.
Resetting the maximum and minimum temperatures in controller memory.
To erase the two temperatures, it’s necessary to clear or reset the controller memory.
The resetting procedure is carried through when pressing the
and button at the same time in 3 seconds.
After 3 seconds a prolonged beep sounds and the memory is clear. The memory is now cleared to start again
with storing the warmest and coldest temperatures.
Notice: The operation and resetting of maximum and minimum temperatures is always possible, even when the
key pad is locked.